Matsui Ec 1000 User Manual
2
Warner Electric • 800-825-9050
819-0041 • P-210
Contents
Installation Instructions . . . . . . . . . . . . . . . . . . .2
Torque Tabs . . . . . . . . . . . . . . . . . . . . . . . . . . . .4
Electrical Coil Data . . . . . . . . . . . . . . . . . . . . . . .5
Burnishing and Maintenance . . . . . . . . . . . . . . .6
Illustration Drawings
EC-375 EC-475 EC-650 . . . . . . . . . . . . . . .8
EC-825 . . . . . . . . . . . . . . . . . . . . . . . . . . . .12
EC-1000 EC-1225 . . . . . . . . . . . . . . . . . . .16
Warranty . . . . . . . . . . . . . . . . . . . . . .Back Cover
Failure to follow these Usb drivers free download.
instructions may result in product damage,
equipment damage, and serious or fatal
injury to personnel.
Installation Instructions
Electro-Clutch
A. Mounting the Electro-Clutch
1. Ideally, the Electro-Clutch should be mounted
on a through-shaft for firm support. In the
case of a stub shaft, the stub should be as
long as the clutch assembly, although for
moderate duty applications a shaft which is
2/3 or more the length of the assembly
normally provides adequate support.
2. Insert the key in the shaft. If the keyseat is
opened at one end of the shaft, prick punch
the shaft to prevent the key from working out.
3. Slide the assembled Electro-Clutch on the
Simply tap any app in the list to launch it. It makes it super easy to test these apps on an actual mobile device. Free mobile app builder. With this tester app, all mobile apps created by you in Tiggzi are shown in a list.
shaft. (When the Electro-Clutch is mounted
on a stub shaft, the set collar end of the
clutch should be toward the support
bearings.) Tighten the setscrews in the set
collar. (Figure 1)
Figure 1
4. Secure the torque arm to the tab on the field
and rotor assembly. Secure the other end of
the torque arm to a solid base. Under no
circumstances should the torque arm be
pinned down so tightly that it preloads the
bearing. For more information on torque
tabs, see page 4.